两个三维柔性功能化双苯并咪唑金属N-杂环卡宾的合成和结构

由1,1'-双苄基-3,3'-氧双(亚乙基-2,1)-二苯并咪唑六氟磷酸盐(L1)和1,1'-双(吡啶-2-甲基)-3,3'-氧双(亚乙基-2,1)-二苯并咪唑六氟磷酸盐(L2)为配体合成了[Hg(C₃₂H₂₈N₄O)](CH₃COO)(PF₆)₂(1)和[NiCl(C₃₀H₂₈N₆O)](PF₆)₂(2),并对其进行了结构表征。配合物1是一个罕见的三价态Hg配合物,为单斜晶系P2₁/c空间群,配合物2为单斜晶系P2₁/n的配合物。1和2中存在O-H…F,C-H…F,C-H…Cl,C-H…π,P-F…π氢键作用和π-π堆积作用,并以此分别形成了3D超分子结构。     

Characterization and reactivity of γ-Al_2O_3 supported Pd–Ni bimetallic nanocatalysts for selective hydrogenation of cyclopentadiene

Several g-Al2O3 supported Pd–Ni bimetallic nanocatalysts(Pd–Ni(x:y)/Al2O3; where x and y represent the mass ratio of Pd and Ni, respectively) were prepared by the impregnation method and used for selective hydrogenation of cyclopentadiene to cyclopentene. The Pd–Ni/Al2O3 samples were confirmed to generate Pd–Ni bimetallic nanoparticles by X-ray diffraction(XRD), X-ray photoelectron spectroscopy(XPS) and transmission electron microscopy(TEM). The catalytic activity was assessed in view of the effects of different mass ratios of Pd and Ni, temperature, pressure, etc. Among all the samples, the Pd–Ni(1:1)/Al2O3(PN-1:1) catalyst showed extremely high catalytic ability. The conversion of cyclopentadiene and selectivity for cyclopentene can be simultaneously more than 90%.     

三维有序结构的金掺杂纳米TiO_2修饰电极用于H_2O_2的测定

在ITO玻璃表面构建了三维有序多孔结构的金掺杂纳米Ti O2薄膜(3DOM GTD/ITO),同时制备了一种细胞色素c(Cyt c)酶生物传感器(Cyt c/3DOM GTD/ITO)。通过透射电镜(TEM)、扫描电镜(SEM)对修饰电极进行表征。紫外-可见光谱实验表明吸附在GTD上的Cyt c能够保持其生物活性,二级结构未被破坏。同时研究了Cyt c在3DOM GTD/ITO修饰电极表面的直接电化学及对H2O2的电催化行为。结果显示,Cyt c在3DOM GTD/ITO修饰电极上有显著的直接电化学响应,峰电流与扫描速度呈线性关系,说明该电极过程是表面电化学控制过程。Cyt c/3DOM GTD/ITO修饰电极对H2O2具有良好的催化性能,线性范围为3.0×10-7~1.70×10-5mol/L,检出限为3.6×10-8mol/L(S/N=3),响应时间为5 s,且该修饰电极具有较好的重现性和稳定性。     

二价与四价金属离子等摩尔共掺杂的锂离子电池正极材料LiMn1.9Mg0.05Ti0.05O4的制备与表征

以氢氧化锂、乙酸锰、硝酸镁和钛酸丁酯为原料, 以柠檬酸为螯合剂, 采用溶胶-凝胶法制备了二价镁离子与四价钛离子等摩尔共掺杂的尖晶石型锂离子电池正极材料LiMn_1.9Mg_0.05Ti_0.05O₄. 采用热重分析(TGA), X射线衍射(XRD), 扫描电子显微镜(SEM), 透射电子显微镜(TEM)和电化学性能测试(包括循环伏安(CV)和电化学交流阻抗谱(EIS)测试)对所得样品的结构、形貌及电化学性能进行了表征. 结果表明: 780℃下煅烧12 h 得到了颗粒均匀细小的尖晶石型结构的LiMn_1.9Mg_0.05Ti_0.05O₄材料, 该材料具有良好的电化学性能, 在室温下以0.5C倍率充放电, 在4.35-3.30 V电位范围内放电比容量达到126.8 mAh·g^-1, 循环50 次后放电比容量仍为118.5mAh·g^-1, 容量保持率为93.5%. 在55℃高温下循环30次后的放电比容量为111.9 mAh·g^-1, 容量保持率达到91.9%, 远远高于未掺杂的LiMn₂O₄的容量保存率. 二价镁离子与四价钛离子等摩尔共掺杂LiMn₂O₄, 改善了尖晶石锰酸锂的电子导电和离子导电性能, 使其倍率性能和高温性能都得到了明显的提高.     

[12] ane N_3-based BODIPY as a selective and sensitive off–on sensor for the sequential recognition of Cu~(2+) ions and ADP

A novel [12]aneN3-based BODIPY sensor 1 can be applied in the sequential recognition of Cu2 and ADP in aqueous solution and living cells with high selectivity and sensitivity     

Threading Chalcogenide Layers with Polymer Chains

Inserting polymers into a crystalline inorganic matrix to understand the structure, position, and the structure–property relationships of the resulting composites is important for designing new inorganic‐organic materials and tuning their properties. Single crystals of polymer‐chalcogenide composites were successfully prepared by trapping polyethyleneglycol within a selenidostannate matrix under surfactant‐thermal conditions. This work might provide a new strategy for preparing novel crystalline polymer‐inorganic composites through encapsulating polymer chains within inorganic matrices.     

纳米二氧化钛-氧化锌/硅溶胶/导电胶复合材料固定联吡啶钌制备磷酸可待因电化学发光传感器

利用硅溶胶的成膜性、纳米二氧化钛-氧化锌大的比表面积及导电胶的粘结性,制备了纳米二氧化钛-氧化锌/硅溶胶/导电胶复合材料,基于此复合材料将联吡啶钌固定到金电极表面,制备了磷酸可待因电化学发光(ECL)传感器.在优化的实验条件(800 V负高压、扫描速度100 mV/s,磷酸盐缓冲体系(pH 6.5))下,可待因浓度在1.0×10-7～1.0×10-4 mol/L范围内与电化学发光强度呈良好的线性关系(r2=0.9973),检出限为2.56×10-8 mol/L (S/N=3).传感器表现出良好的重现性与稳定性,连续平行测定1.28×10-5 mol/L可待因溶液10次,发光强度的相对标准偏差(RSD)为2.7％;室温下保存10天后,发光强度为初始值的92％以上.测定可待因药物实际样品的加标回收率在99.3％ ～ 102.5％之间.     

自组装短肽GFS-2构建新型三维细胞培养支架材料

典型的自组装短肽在水中可形成稳定的β-sheet二级结构,在生理性环境下则能够形成稳定的纳米纤维,可进一步形成含水量达99%的水凝胶,具有高纯度、可降解及无免疫反应等突出优点,能模拟生物体内的三维基质环境而作为细胞三维培养的新型生物材料。本文主要采用了圆二色谱仪、原子力显微镜、倒置显微镜等探究新型短肽GFS-2的自组装性能及其在细胞三维培养中的应用。此研究可能会启发设计更多的新型自组装短肽服务于化学、生物材料、医学工程等领域。     

Discrete Rectangles,Prisms, and Heterometallic Cages from a Conjugated Cp*Rh‐Based Building Block

By carefully selecting an existing synthetic strategy and suitable coordination subunits, constructing desired coordination geometries is no longer that difficult to accomplish. Herein, a new strategy to construct a series of unprecedented structures by using conjugated Cp*Rh‐based complex BN‐OTf (Cp*=η⁵‐C₅Me₅) as the building block is proposed. DFT calculations revealed extensive delocalized π bonds in the subunit. With BN‐OTf , rectangular macrocycles TN‐bpy and TN‐bpe were controllably synthesized. Single‐crystal XRD studies confirmed one‐dimensional stacking channels for the tetranuclear structure. Notably, the starting ligand imidazole‐4,5‐dicarboxylate was found to act not only as a tetradentate but also as a hexadentate ligand that can coordinate to further metal ions. Subsequently, [4 Rh+1 M] heterometallic complexes HMZ (M=Cu and Zn) were accessed by chelating borderline hard/soft Lewis acids. With TN‐Linker or HMZ , two routes resulted in the [8 Rh+2 M] heterometallic cages HMC (M=Cu and Zn) with excellent crystallinity and stability. Surprisingly, when BN‐OTf bonded to rhodium itself, triangular prisms TP‐Linker were obtained with high solubility after being linked by bipyridine linkers. Both the X‐ray structure and ¹H NMR spectrum confirmed the novel isomerization of the triangular structures. All of the compounds were obtained in high yields and were fully characterized by ¹H NMR spectroscopy, elemental analysis, IR spectroscopy, and in most cases single‐crystal X‐ray structure determination.